Each fitting is manufactured from high-grade polypropylene polymers mechanically tested to conform to standards EN12201-2 for use in potable water systems and in systems that require components to be WRAS approved. The non-metallic construction of materials is suitable for contact with drinking water having met the requirements of BS 6920-1 :2000.

Unscrew the nut and clinching ring from the fitting and slide tapered edge first onto the pipe. Ensure the ‘O’-ring is in place and free from any twists before pushing the pipe into the compression fitting body past the ‘O’-ring right up to the pipe stop (a ridge located in the centre of the fitting body). Push the clinching ring to the edge where the pipe meets the fitting and twist the nut onto the thread tightly. HydroSure compression fittings can be removed and reused, simply unscrew the nut and pull the pipe from the main body of the fitting. The clinching ring can then be prised off and placed back into the main body.

HydroSure compression fittings arrive complete with silicone grease already applied precisely around the internal ‘O’-ring. The primary function of greasing a fitting before pipe installation allows the pipe to slide past the ‘O’-ring without causing any gouges from jagged edges. Top Tip: Blunt the end of the pipe before installing it into a fitting using a pipe chamfering tool.

Once the pipe is installed correctly, the internal ridge, called the pipe stop creates a smooth free flow for water to pass through the connection. Unlike other brands, this HydroSure compression fitting has a smooth edge that protects against any friction build-up within the system that will disrupt water flow and reduce the performance of emitters.

HydroSure compression fittings feature an internal thrust ring that applies pressure to the clinching ring when the nut is sufficiently tightened. As this pressure between the nut and thrust ring is applied, the clinching ring, with sharp teeth like edges, lock themselves securely into the pipe wall. This combined action is expertly constructed for maximum security and reliability against pipe dislocation from the fitting. Please note: For threaded compression connectors, it is advisable to seal the join by wrapping PTFE/Teflon tape at least twice around the male thread.

Constructed from high-grade polypropylene polymers engineered for long-lasting reliability against degradation and pipe dislocation. The ‘O’ ring is manufactured from anti-perishable strong and durable rubber to ensure a long-lasting watertight seal even at high working pressures up to 16 Bar.