HydroSure Adjustable 360° Rotor 200mm Sprinkler Assembly -100 L/h – 3.65m Radius - Pack of 10

The strong ‘D’ shaped design of the included sprinkler forces water from the outlet, increasing its exit velocity meaning it can accelerate water to a much further radius than more average sprinklers. The perfect solution for watering multiple plants using just one emitter. The robust sprinkler design also incorporates built-in support bearings that protect the internal mechanisms during constant rotation meaning the sprinkler is less likely to wear out promoting a longer-lasting irrigation system.

This pre-assembled solution arrives with all the components you need included. To install, pierce a hole in the LDPE pipe using the sharp end of the ground stake. Connect the 4mm barbed joiner already attached to the end of the 4mm feeder tube into the hole just created. The 30cm length of the feeder tube allows for ultimate flexibility when choosing where to place your micro sprinkler. Once you have chosen where to situate, secure it into the ground using the stake.

The built-in 30cm ground stake ensures the sprinkler head remains securely in position and elevates the height of the micro sprinkler. Increasing the height furthers the diameter and radius water is outputted from the sprinkler head, ensuring the perfect resolution for watering taller plants or areas of your garden with a more dense foliage canopy. Top Tip: When watering tall shrubs and trees, increase the watering height by unthreading the sprinkler head and connecting a Rigid Riser to the outlet.

Manufactured using UV-stabilised and weather-resistant acetal and nylon plastics to ensure long life and protection against deterioration even when subject to harsh climates and sunlight. Cheaper plastics will begin to fade and crack but you can be certain HydroSure micro sprinkler heads are built to last. This high-quality sprinkler is also resistant to most common agricultural chemicals.

Micro sprinklers, compared with drip emitters, disperse water over a larger surface area. This is advantageous on sandier soils as water can disperse laterally rather than vertically downward ensuring enough water remains within the root zone rather than sinking out of the plants reach. Micro sprinklers conserve water by emitting at low precipitation rates and allow for longer run times yet prevent any water runoff to ensure water goes where it is needed. This highly efficient method of watering allows for irrigation either above or below the plant foliage.

Micro sprinklers distribute large amounts of water at low pressures meaning they are more efficient than more pressurised methods - perfect for domestic usage. Micro sprinklers work best at water pressures between 1.5 and 3.0 bar. At this water pressure, this sprinkler produces an output of around 100 L/h with the ability to throw water to a radius of up to 3.65m. The water pressure from a domestic tap usually exceeds the required pressure for a micro sprinkler system to function optimally. Use a pressure regulator/reducer at the start of your system to regulate the pressure to the correct level.