Product code
725025
Pack of 3 HydroSure WRAS Approved Compression O'Ring 25mm
A replacement o'ring with a flared edge to promote tightening around the pipe wall and prevent water from escaping through the fitting exterior. See Full Description
A replacement o'ring with a flared edge to promote tightening around the pipe wall and prevent water from escaping through the fitting exterior.
Solutions that Work
For Top Tips on how to use Compression Fittings, read our Buyers Guide.
Installing a Compression Fitting
To install a replacement ‘O’-ring, simply unscrew the nut and pull the pipe from the main body of the fitting. Then, remove the thrust ring holding the current ‘O’-ring in position. Place the new ‘O’-ring into the fitting body making sure it is free from any twists and re-place the thrust ring back inside the body of the fitting. The pipe can then continue to be installed as normal.
Silicone Grease for Compression Fittings
Before inserting the ‘O’-ring into the compression fitting body, apply some silicone grease to the fitting before pipe installation. This allows the pipe to slide past the ‘O’-ring without causing any gouges from jagged pipe edges. Top Tip: Blunt the end of the pipe before installing it into a fitting using a pipe chamfering tool to reduce the risk of damaging the ‘O’-ring.
WRAS Approved Compression Fitting
Each part is manufactured from high-grade polypropylene polymers mechanically tested to conform to standards EN12201-2 for use in potable water systems and in systems that require components to be WRAS approved. The non-metallic construction of materials is suitable for contact with drinking water having met the requirements of BS 6920-1 :2000.
| Product Code | 725025 |
|---|---|
| Units Per Pack | 3 |
| EAN | 5056287719284 |
| Material | Plastic |
| Fits Pipe Size | 25mm Outer Diameter MDPE/HDPE Pipe |
| Connection Type | Compression |
| For Pipe Type | HDPE, MDPE |
| Price Per Unit (Inc. VAT) | 0.43 |
